|
|
|
| |
Here are a few handy tips to help you care for your products, along with useful |
| |
information on the materials used to make them. |
| Q: |
Acrylic Features |
| A: |
·Unlimited design potential and flexibility
·High-quality cast acrylic sheets molded in one single piece
·Color permeates the entire sheet
·Integrated pigment makes scratches less noticeable
·Color won't fade, retains luster
·Warm to the touch, retains heat
·Soft and luxurious appeal
·Mirror-like finish resists cracks and chips
·Cleans easily with mild soap
·Very light (compared to porcelain and cast iron)
·Non-corrosive, non-porous
·Rust, crayon and permanent market won't stain
·Recommended for durability, easy to maintain and repair
·Comes in a wide variety of colors
·Used for bathtubs, showers, tub showers and sinks
·Sectionals have extra large joints - watertight
·Resists mold and mildew |
| |
|
| Q: |
Acrylic Maintenance Tips |
| A: |
Clean your acrylic shower or tub shower regularly with a non-abrasive spray, cream- based cleansing agent or dishwashing liquid. Never use abrasive cleansers, scrapers, metal brushes, or anything that could scratch or dull the surface.
To add luster and remove fine scratches, polish regularly with Lumacream, available at all shower dealers. Car wax may also be used.
The use of Lumashine, a special acrylic surface cleaner, is also recommended to clean, add shine and create an anti-static, dust-repellent surface.
Turpentine or paint thinner may be used to remove paint strains.
Use a plastic or wooden spatula covered with a moist cloth to remove plaster residue. |
| |
|
| Q: |
Whirlpool Maintenance Tips |
| A: |
Clean the piping and pump once a month with Mister cleanser or dishwashing liquid (2 tablespoons). Fill the bathtub with hot water (max.104°F/40°C) to two inches (5 cm) above the jets, add the cleansing agent, and turn on the whirlpool system for ten minutes. Empty the bathtub. Use cold water to rinse, turning the system back on for ten minutes, while keeping the air controls turned off. |
| |
|
| Q: |
Air Massage Maintenance Tips |
| A: |
20 minutes after the system is activated, the dry cycle automatically starts up for 30 seconds to dry the jet covers.
If you take a bath without operating the whirlpool system, or if your bathtub remains full of water for more than 10 minutes after the system has been turned off, you must turn on the blower for about 30 seconds after emptying the bathtub to dry the jet covers.
The system does not require any specific maintenance, and the shell can be cleaned much like any other bathtub. |
| |
|
| Q: |
Cabinets Maintenance Tips |
| A: |
DO:
Dry off any dampness or any liquids immediately with a clean dry towel.
Clean off any heavy or sticky residues with a warm, mild solution of furniture oil soap or equivalent.
Occasionally apply lemon oil or a quality furniture polish.
Touch up scratches with a scratch cover or a matching colored paste wax shoe polish
Clean white laminate or foil doors and drawers with a mild liquid soap and warm water. Dry with soft clean cloth immediately.
DON’ T:
Use abrasives, strong detergents, chemical agents, or rags and sponges used for other chores to clean your cabinets.
Use a wax because over time it will cause a film that picks up dirt and smoke.
Use a silicone-based polish.
Drape wet towels over the doors or end panels. |
| |
|
|
|